Product Search - Lymink Bidet

Next Last

DISCLAIMER:
Whilst all care is taken to provide accurate information with respect to the item described, the Independent Living Centre (ILC) is not involved in product design or manufacture, and therefore not in a position to guarantee the accuracy of the information provided. Selection of equipment, which is both suitable and appropriate for individual needs remains the responsibility of the person(s) considering requisition, and no responsibility is taken by the ILC for any loss or injury caused through use of the equipment or alleged to have arisen through reliance upon information provided. As information is subject to change any enquiries should be directed to the manufacturer.

Item Details

Lymink Bidet

ILC Reference NO 81:25:004
Item sourced from ILC SA database

Short Description
A bidet toilet seat unit that provides a warm seat, adjustable temperature, front and rear spray jets and a warm air blow drier with two heat settings.

Price Guide
Refer to supplier information for pricing details.

More Details
The bidet replaces a conventional toilet seat and is secured into place by two screws.

The bidet is suitable to fit most toilet pans.

A tap and a power point are required to install the bidet unit. There are regulations governing the positioning of power points in wet areas. As these vary from state to state advice needs to be sought from an electricity authority.

The bidet is required to be installed by a plumber, and this can be arranged through the supplier.

Method Of Use
Power: Press button power switch located on the left side of seat.

Cleansing: Rear and front water cleansing nozzles are operated by turning knobs on the right and left side of the seat respectively. Cleansing action lasts 40 seconds.
Temperature of seat and water jets can be adjusted by turning a separate knob on the
left side of seat.

Drying: Press button switch with two heat settings on right side of seat. Drying action lasts approximately 60 seconds.

Factors To Consider
A product approval is required for any plumbing product installed in South Australia (WaterMark). The appropriate backflow prevention requirements must be addressed as part of the installation.
Compliance with relevant requirements is indicated by written certification that a product has been assessed as compliant.
Purchasers are advised to check with the supplier or manufacturer of this item as to its compliance with relevant approvals.

Standards
Some assistive technology needs to meet Australian or other standards. Standards may relate to materials, manufacturing and installation. Products that meet Australian or international standards will have written certification. To find out if a product meets Australian Standards ask the supplier to show you the certificate. For a fact sheet about standards contact us or visit www.ilcaustralia.org/home/standards.asp

Supplier Information - click to supplier for contacts details
BIDET PTY LTD , WILBERFORCE, NSW

Additional /images
No additional /images apply to this item

First Prev Next Last